afmetalsmith (afmetalsmith) wrote,
afmetalsmith
afmetalsmith

I was sadly uninspired today... but that's good! Because I worked on several ongoing projects!

To wit: The basic raising etc. is done on my next anvil ring (a hollow ring similar to the one in my icon, but lots bigger since it's potentially for someone with bigger fingers). I did some work to create a form I can use to even out the gap for the enamel, as well.

I also worked on a pendant that I started probably 10 years ago. I still like the concept, or I would have dumped it. Anyway, at this point it needs about 2 more steps- 1 of which is polishing a particular are- and it'll be done. Finally!

And I have a couple of heart-shaped potential scent lockets which needed about 50 million little holes drilled. And so I did that. They are now ready for both the joins, and the decorative touches which required all those holes, and so another 3 soldering ops should do it for the hot work (the pivot, and the 2 halves of the bails).

I have a ton of new ideas for new projects, but am firmly committed to not infinitely creating new, unfinished projects. So my interest in new stuff means I HAVE to finish some pending pieces! However, even though it's necessary, I'm enjoying the work and results.
Subscribe
  • Post a new comment

    Error

    Anonymous comments are disabled in this journal

    default userpic

    Your reply will be screened

    Your IP address will be recorded 

  • 0 comments